Clearances; Draft Diverter; Door Knob - COZY VC501A Installation And Operation Instructions Manual

DRAFT DIVERTER
The draft diverter must be installed in the same atmospheric
pressure zone as the combustion air supply for the main burner.
DOOR KNOB
Remove frolTl the inside of the casin_ door and assemble to
the outside of the door. VC201 and VC202 have fin_er holes
in the door in lieu of knob.
34 IN. T 18 IN.
"_5.72 CM
86.36CM
g2 IN.
55_88CM
CLEARANCES - VC20, VC35, VCR35
31IN. I 4" 18 IN"
45.72 CM
78.7 CM
_19 IN.
48.3 CM
{
CLEARANCES
If the area where the appliance is to be installed contains
carpeting, tile, or combustible materials, other than wood
flooring, the appliance shall be installed on a metal plate
(stoveboard), a wood panel, or other non-combustible
materials. The use of ceramic or quarry tile is acceptable
and provides an appealing surface that is easily cleaned.
This material is to extend 2 inches flom each side and 12
inches from the fiont. It is advisable to extend this to the
wall behind the appliance.
Clearances to combustibles are as follows:
From jacket to adjacent side walls, 2" on the 20/35, and
6" on the 50/70. Maintain adequate clearance on right
side for accessibility.
From rear surface vertical vent pipe to rear walls 6".
From rear of unit to rear walt, 13" on 20/35, and 14" on
the 50/70.
• From top ofheater to ceiling, 34" on the 20/35, and 31"
on the 50/70.
From top of heater to aW overhanging projections such
as a mantle or window silt is 22" on the 20/35, and 19
inches on the 50/70 models, with a maximum horizontal
extension of 18 inches.
The clearances around the air openina into the combustion
chamber must be maintained and the burner must be kept
clean.
Do not permit dust or dirt to accumulate here. The other
clearances previousN mentioned must be maintained.
There must be adequate room provided and maintained
around the heater for accessibility and t\_r the flow of
combustion and ventilation air.
?LEARANCES - VC50 & VC70,
VCR50 & VCR70
Page 7