Wall Mount - COZY VFT201 Installation And Operation Instructions Manual

INSTALLING HEATER WALL MOUNT
(VFM20, VFT20, VFM30, VFT30)
WALL MOUNT (VFM6, VFM10, VFT10)
STEP 1. Remove walt mounting bracket froln back of
heater.
STEP2. Locate wall stud.
STEP 3. Attach wall mounting bracket to wall stud
with top at desired heigllt, using (2) screws provided.
Make sure top of bracket is level. See Fimlre 2.
STEP 4. Hang top of heater on wall mounting bracket.
STEP5. Remove bottom flont panel.
STEP 6. Secure back of heater to wall, utilizing
anchors (if necessary) or wood screws. See Figure 3.
WALL STUD
o O O
O O
--IWALL
MOUN_ING
BRACKET
FIGURE 2
J
/
HOLES FOR MOUNTING BACK OF
HEATER TO WALL
FIGURE 3
Page 9
STEP 1. Relnove wall mounting bracket fiom back of
heater.
STEP 2. Locate two studs.
STEP 3. Attach wall mounting bracket to wall studs with
top at desired height using (2) wood screws provided.
Make sure top of bracket is level. See Figure 4.
STEP 4. Hang top of heater over wall mounting bracket.
STEP 5. Remove bottom front panel.
STEP 6. Secure back of heater to wall, utilizing anchors (if
necessary) or wood screws. See Figure 3.
0 o 0
© ° ©
FIGURE 4
INSTALLING VF-FSK FLOOR BASE KIT
STEP 1. Remove floor base fiom carton.
STEP 2. AIiN1 screw holes in base to holes in heater
bottom.
STEP 3. Make sure that cut-out in top of floor base aliNls
with cut-out in bottom of heater and the other cut-out in
bottom of heater and the other cut-out in base if facing
towards back of unit (see illustration below).
STEP4. Attach floor base to bottom of heater using four
#8 screws (provided).
NOTE: Floor bases are t\_ruse on VFM 10, VFT 10, VFM-
20, VFT-20, VFM30 and VFT30 only. The VFM6 Series has
no base and is not approved for use with one.
HEATER
¢lake sure this cut-out
faces back of heater.