Download Print this page

COMPANION 315.101000 Owner's Manual page 7

1/2 in. electric drill double insulated

Advertisement

WARNING: Yourdrillshould never b e
connected topower s upply when youare
assembling parts, m aking a djustments, installing
orremoving drillbits,cleaning, or when notin
use.Disconnecting
yourdrillwillprevent
accidental starting thatcould cause serious
personal injury.
SINGLE SPEED SWITCH
See Figure 2.
Your drill has a single speed switch. To turn your drill
ON, depress the switch trigger. Release switchtrigger
to turn your drill OFF.
LOCK-ON
BUTTON
SWITCH
TRIGGER
Fig. 2
LOCK-ON BUTFON
See Figure 2.
Your drill is equipped with a lock-on feature, which is
convenient when continuousdrillingfor extended
periodsof time is required.To lock-on, depress the
switch trigger, push in and hold the lock-on button
locatedon the side of the handle, then release switch
trigger. Release lock-on button and your drillwill
continue running.
To release the lock, depress the switch trigger and
release.
If you have the lock-on feature engaged during use
and your drill becomes disconnectedfrom power
supply, disengage the lock-on feature immediately.
_lb WARNING:
Before connecting yourdrill to
power supply source, always check to be sure it
is not in lock-on position(depress and release
switch trigger). Failure to do so could resultin
accidental starting of your drillresultingin
possibleserious injury. Also, do not lock the
trigger on jobs where your drill may need to be
stopped suddenly.
REVERSIBLE
See Figure 3.
Your electricddll has the feature of being reversible.
The directionof chuck rotationis controlledby a lever
located above the switchtrigger. With your drillheld in
normal operating position,the directionof rotationlever
should be positionedto the left of the switch for drilling.
The drilldirectionis reversedwhen the lever is to the
rightof the switch.
The design of the switchwill not permit changingthe
direction of rotationwhile the drill is running. Release
the switch triggerand allow the drill to stop before
changing its direction.
Note: Your drill will not run unlessthe switch lever is
pushed fully to the left or right.
FORWARD
REVERSE LEVER
Fig. 3
7

Advertisement

loading