Advertisement
_k
WARNING:
When servicing, use only identical
replacement pads. Use of any other part may
create a hazard or cause productdamage.
GENERAL
Only the parts shown on parts list, page 13, are
intendedto be repaired or replaced by the customer.
All other parts represent an importantpart of the
double insulationsystem and should be serviced only
by a qualified Sears service technician.
Avoid using solventswhen cleaning plasticpads.
Most plasticsare susceptibleto damage from various
types of commercial solventsand may be damaged
by their use. Use clean clothsto remove dirt, carbon
dust, etc.
,_
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contactwith plastic parts. They
contain chemicalsthat can damage, weaken or
destroyplastic.
It has been found that electrictools are subject to
accelerated wear and possiblepremature failure when
they are used on fiberglassboats, sports cars,
wallboard,spackling compounds,or plaster. The
chips and grindingsfrom these materialsare highly
abrasive to electdc tool parts such as bearings,
brushes, commutators,etc. Consequently, it is not
recommended that this tool be used for extended
work on any fiberglass material, wallboard, spackling
compounds,or plaster. During any use on these
materials it is extremely importantthat the tool is
cleaned frequently by blowingwith an air jet.
_,
WARNING:
Always wear safety gogglesor
safety glasses with side shields during power
tool operation or when blowing dust. If operation
is dusty, also wear a dust mask.
LUBRICATION
All of the bearings in this tool are lubricatedwith a
sufficientamount of high grade lubricantfor the life of
the unit under normal operating conditions.Therefore,
no further lubricationis required.
EXTENSION
CORDS
The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent
tool overheating, use an extension cord that is heavy
enough to carry the current the tool will drew.
A wire gage size (A.W.G.) of at least 16 is
recommendedfor an extension cord tO0 feet or less
in length. When workingoutdoors,use an extension
cord that is suitable for outdooruse. The cord's jacket
will be marked WA.
_k
CAUTION: Keep extension cordsaway from the
ddllingarea and positionthe cord so that it will
not get caught on lumber, tools, etc., dudng
ddllingoperation.
WARNING:
Check extension cords before each
use. If damaged, replace immediately.Never use
tool with a damaged cord since touchingthe
damaged area could cause electrical shock
resulting in serious injury.
Extension cords suitable for usewithyourdrillareavailable
at your nearest Sears Retail Store.
12
Advertisement
