Advertisement
Available languages
Available languages
WARNmNG
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
Keep at least 5 ft. (152 cm) clearance on all sides of generator
including overhead.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark attester, maintained in
effective working order, complying to USDA Forest service
standard 5t00-IC or later revision. In the State of California a
spark attester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
Clean
and inspect
the spark attester
as follows:
I.
To remove muffler heat shield from muffler, remove
four screws that connect guard to muffler bracket
(Figure 12).
.
H
Spark Arrester
Screen
Huffler
Heat Shield
.
3.
Remove four screws that attach spark arrester
screen.
Inspect screen and replace if torn, perforated
or
otherwise
damaged. DO NOT use a defective screen. [f
screen is not damaged, dean it with commercial
solvent.
4.
Reattach
screen
and muffler guard.
C[ean
Cooling
System
Over time debris may accumulate in cylinder cooling fins
and cannot be observed without
partial engine disassembly.
For this reason, we recommend
you have a authorized
service dealer clean the cooling system (Figure 13) per
recommended
intervals (see "Maintenance
Schedule" on
page I 3). Equally important
is to keep top of engine free
from debris. See "Generator
Cleaning".
Clean
The carburetor
on this engine
is low emission.
It is
equipped
with a non-adiustable
idle mixture
valve and
governed
idle, if equipped.
Governed
idle and top speed
have been set at the factory. If adiustment
is required,
see a
authorized
service
dealer.
CAUT(ON
DO NOT tamper
with governed
speed. Generator
supplies
correct
rated frequency
and voltage
when
running at governed
speed.
DO NOT
modify generator
in any way.
1
Advertisement
