Cleaning And Care; Cleaning The Dryer; Cleaning The Exhaust Duct; Cleaning The Moisture Sensor - Bosch Nexxt Series Instruction Manual

Cleaning and care
Cleaning the dryer
TO AVOID
RISK OF EXPLOSION!
Never use solvents or highly
flammable liquids for cleaning.
Incorrect cleaning may damage the
dryer. Do not spray with a water jet.
Do not use scouring agents or
all-purpose cleaners. Do not use
steam cleaners.
Wipe the housing and fascia with a soft
cloth and soapy water only.
Wipe the drum, door seal and inside of
the door with a damp cloth only.
Cleaning the exhaust duct
Inspect and clean the exhaust ducting
at least once a year to prevent
clogging. A partially clogged exhaust
will lengthen the drying time and will
result in poor performance of the dryer.
13 Turn off the circuit breaker
13 Pull out power supply plug
13 Disconnect the duct from the
dryer.
13 Vacuum and reconnect the duct.
Cleaning the moisture
sensor
The moisture sensor has to be cleaned
because a fine layer of transparent
buildup is deposited on the sensors.
This deposit can easily be removed by
wiping the sensors (the two bars next
to the lint filter) with a cloth and a little
white vinegar.
Use white vinegar only!
Clean the moisture sensor once a
month.
Cleaning the bearing
shield
Over time, fluff from the drying process
collects in the bearing shield.
This fluff can be easily removed using
your vacuum cleaner, at least once a
month.
Cleaning the MISTCARE TM
Nozzle
Once a year inspect the nozzle outlet.
If you suspect blockage, wipe the
outside of the nozzle with a cloth
moistened with vinegar. If the nozzle is
completely blocked, consult the
troubleshooting guide (see page 26) for
removal and cleaning instructions. If
the nozzle remains blocked, call
customer service (see page 26).
Change the light bulb
The dryer light turns on inside the drum
when you open the door.
To change the light bulb:
13 Set program selector to "Off".
13 Turn off the circuit breaker.
13 Pull out power supply plug.
13 Open the door and locate the light
bulb on the upper left side of the
seal.
13 Loosen the screw of the cover and
open the cover.
13 Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
%
Cl
Cl
Parts are available at
www.boschappliances.com
or by calling 1-800-944-2904.
Replace the cover and secure with
the screw.
Plug in dryer or reconnect power
supply.
24