Getting Ready; Deep Cleaning; When You're Done - Bissell Series 1720 User Manual

Gettingready
1. Remove Vacuum Flex Hose completely from Onboard
Hose Storage.
2. Attach 4" Tool, 6" Tool* or Crevice Tool* to Grip Trigger
Unit by pressing Tool onto Grip/Trigger Unit firmly;
until button snaps into hole. Make certain Tool is
securely attached.
3. Unwrap Power Cord completely from Onboard Cord Storage
and plug into 120 Volt. 60 Hz grounded outlet as described
in Important Safety, Instructions, page 2.
4. If cleaner starts when first plugged in, switch cleaner off
until ready for use.
5. Move Power switch to ON position.
6. Press and hold Spray Trigger on Grip/Trigger unit. Spray
will start in a few seconds.
7. Raise Upholstery/Carpet Tool slightly to check for spray. If
spray does not start, press firmly on the front of the Solution
Tank while depressing Spray Trigger.
*Optional on some LittleGreen models. Toorder optional
parts not originally included in )x_urLittleGreen model, call
BISSELL Consumer Services
1-8OO-237-7691
Monday - Friday 8 a.m. -- 7 p.m. EST
Saturday 9 a.m. -- 1 p.m. EST
Pre-treating
1. Pre-treat stained or highly soiled areas: Hold
Upholstery/Carpet Tool or Crevice Tool 4"- 6" above carpet
or upholstery, and pull trigger to spray clezming solution.
2. Wait 3-5 minutes before cleaning.
Deep cleaning
1. Place Upholstery/Carpet Tool directly on soiled surface at
arms length. Apply downward pressure on Upholstery/Carpet
Tool and pull toward you. while pulling trigger to spray
cleaning solution.
2. Repeat, keeping Upholstery/Carpet Tool firmly against
surface. Continue until no more dirt can be removed.
Do not overwet.
3. Release spray trigger. Vacuum area until no more
cleaning solution can be removed. [see WHEN
YOU'REnONE, page 6].
4. If Upholstery/Carpet Tool stops spraying, turn off Power
Switch and check cleaning solution level. Refill if needed.
Never mn pump dry.
When you're done
NOTE:Before turning offLittle Green. lift Upholster,'/
CaE_etTool and point upwards. This allows ans' '
water still in the Vacuum FlexHoseto flowinto
the Collection Tank.
1. Turn Power Switch to OFF position.
2. Unplug Power Cord from outlet.
3. Remove and rinse Solution Tank, then
replace.
NOTE: Ifa significant amount of Little Greenformula/
water remains, you may leave it in the Solution
Tank for your riextcleaning task.
4. Remove Collection Tank. Be careful not to
spill dirty,water.
5. Carefully carry. Collection Tank to a toilet or
sink to emp_,.
6. Fill Collection Tank with clean water. Rinse
thoroughly and discard wateE
7. Replace Collection Tank.
8. Disconnect Upholstery/Carpet Tool from
Grip/Trigger unit by pushing down on
button lock and pulling straight off.
(Do NOT twist tools to remove them).
9. Remove brush from Upholstery/Carpet Tool
and clean brash under clean running water.
10. Remove clear plastic view window from
Upholstery/Carpet Tool by pushing on tab
opening while pulling out bottom window
lip. Rinse under clean running wate_
11. Check Spray Nozzle for accumulated dirt
or debris. If necessary,, clean with soft
bristle brush.
12. See PUTTING IT AWAY o n page 7.