Advertisement
Available languages
Available languages
FOR BEST PERFORMANCE
Cut grass when it is dry.
Keep mower blades sharp.
Keep mower deck properly leveled.
Adjust anti-scalp rollers to prevent scalping.
Do not set height of cut too low. For very tall
grass, mow twice.
Do not travel too fast.
Mow with the engine set at full throttle.
When mulching, only remove 1/3 of grass
length per cutting.
Discharge clippings into areas already cut.
Vary cutting pattern with each mowing.
Do not allow grass or debris to collect inside
of mower deck. Clean after each use.
,_
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
IMPORTANT: Proper maintenance
can
prolong the life of unit. The following chart
shows the recommended
service schedule.
Refer to the maintenance
instructions
in the
Engine Manual for additional information.
Interval
Each Use
NOTE: To have full access to the engine, the
seat must be tipped forward (see TIPPING
SEAT FORWARD on page 16) and the hood
opened (see OPENING AND CLOSING
HOOD on page 17).
Task
' Action
Check
_
WARNING:
Safety interlock system failure and improper
Safety
_
operation of unit can result in death or serious injury. Test
Interlock
this system each time the unit is operated. If this system
System
does not function as described, do not operate until repairs
are made (see Safety Interlock System on page 12).
Check
Engage parking brake and engage transmission
bypass lever (see
Parking
MOVING UNIT MANUALLY on page 14). Push unit. If unit rolls,
Brake
contact your Ariens Dealer.
Clean Unit
Clean engine, battery, seat, mower deck, etc. of all dirt and debris. Do
not use solvents, hard cleaners, or abrasives.
Do not spray the unit with water, especially when the unit is warm from
operation. Water can seep into bearings and damage them.
NOTE: Protect painted surfaces with automotive
type wax.
See SPECIFICATIONS
on page 28 for correct tire pressure.
Check
A
CAUTION:
Avoid injury! Explosive separation of tire and rim
Tires
_
parts is possible when they are serviced incorrectly:
•Do not attempt to mount a tire without the proper equipment
and experience to perform the job.
Do not inflate the tires above the recommended
pressure.
Do not weld or heat a wheel and tire assembly. Heat can cause
an increase in air pressure resulting in an explosion.
Welding can
structurally weaken or deform the wheel.
Do not stand in front or over the tire assembly when inflating. Use
a clip-on chuck and extension hose long enough to allow you to
stand to one side.
CAUTION:
Check for worn or damaged mower blades.
Check
Mower
Blades
GB- 15
Advertisement
