Forward Settings - Kyocera ECOSYS FS-C2126MFP Operation Manual

Reception:
4 Rings(FAX/TEL)
5

Forward Settings

6
RX Settings
*********************
RX Settings:
1 *Auto(Normal)
*********************
2
Auto(FAX/TEL)
3 Auto(TAD)
Reception Starts
Reception Print
6
a b
[ Exit ]
7
8
a b
9
1
NOTE:
ringing tone rings. (Refer to Rings on page 6-16.)
To cancel the reception, refer to Cancelling
Transmission (Disconnection of Communication) on
page 3-13.
2
IMPORTANT:
When the number of sheets to be printed exceeds the
number of sheets that can be held, remove all the
paper on the top tray.
NOTE:
Letter at the sender, the send image size will be
reduced at the sender's machine to fit to your
supported paper size. In addition, when the send
image size is too long at the sender and your machine
cannot print the received image into one page, the
image will be divided into several sheets of paper.
3-10
Press the or key to select [RX Settings].
Press the OK key.
Press the or key to select [Auto(Normal)].
Press the OK key.
When a fax has been sent to you, the machine
rings the registered number of times, and then
starts receiving the fax.
After reception has started, the Processing
indicator blinks.
You can change the number of times the
Received originals are output on the top tray with
the print side facing downward. Up to 150 sheets
of plain paper (80 g/m²) can be held on the top tray.
However, the number of sheets varies with the
condition of the paper to be used.
When the original size is larger than A4 or
FAX Operation (Basic)