Material Safety Data Sheet; (Msds); Material Safety Data Sheet (Msds) - Oki B4400 Safety Information Manual

uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expnense.
Note: It is the responsibility of the user to obtain the
required shielded cable in order to ensure
compliance of this equipment with FCC regulations.
Changes or modifications not expressly approved by Oki
Data may void your authority to operate this device.
Industry Canada (IC) Radio Interference
Statement
120-Volt Models
This Oki Data apparatus complies with the Class B limits
for radio interference as specified in the IC Radio
Interference Regulations.
220/240-Volt Models
This Oki Data apparatus complies with the Class A limits
for radio interference as specified in the IC Radio
Interference Regulations.
European Council of the European
Communities
Statement of Electromagnetic Conformance
This product complies with the requirements of the council
Directive 89/336/EEC on the approximation of the laws of
the member states relating to electromagnetic
compatibility.
Statement of Safety Conformance
This product is in conformity with Directive 73/23/EEC on
the harmonization of the laws of Member States relating to
electrical equipment designed for use within certain
voltage limits.
English

Material Safety Data Sheet

# 58378501
Black Toner, Type 10: P/N 43502301,
43502001
All Countries / Regions
For more information, contact Oki Data at: 2000 Bishops
Gate Boulevard, Mount Laurel, NJ 08054-4620.
Emergency Information: call 1-800-654-3282; US and
Canada only.
Emergency First Aid Procedures _______________
Toner swallowed (ingested)
Immediately seek medical attention. Never give anything
by mouth to an unconscious person. If possible, rinse out
mouth and give one or two glasses of water or milk to
drink.
Toner inhaled.
Remove person to fresh air. Seek medical attention.
Toner gets in the eyes.
Flush eyes with large quantities of cool water for 15
minutes, keeping the eyelids open with fingers. If
necessary, seek medical attention.
Toner gets on the skin.
Wash toner off the skin with plenty of cool water and soap.
If necessary, seek medical attention.
Note: Small amounts of toner on skin or clothing can
easily be removed with soap and cold water. Hot
water makes toner harder to remove.
Hazardous Ingredients_______________________
Carbon Black (4-8%)
CAS#: 1333-86-4.
OSHA TWA: 3.5 ppm.
ACGIH TLV: 3.5 ppm.
Styrene (<50 ppm)
CAS#: 100-42-6.
OSHA: TWA: 50 ppm.
ACGIH TLV: 20 ppm.
Other Ingredients __________________________
Styrene Acrylate Copolymer (70-90%)
CAS#: 25767-47-9.
Fatty Acid Ester (0-2.5%)
CAS#: 75587-84-7.
PMMA (0-3%)
CAS#: 9011-14-7
Silicon Dioxide (amorphous) (0-5%)
CAS#: 67762-90-7
Physical Data ______________________________
Physical State: Solid.
Melting/Freezing Point: 110°C (230°F).
Boiling Point: Not applicable.
pH: Not available.
Vapor Pressure: Not available.
Vapor Density (Air=1): Not available.
Evaporation Rate (Butyl Acetate=1): Not available.
Specific Gravity (H
Solubility in Water: Negligible.
Solubility in Solvents: Not available.
Coefficient of water/oil Distribution: Not available.
Appearance and Odor: Black powder, no odor.
Odor Threshold: Not available.
Fire and Explosion Hazard Data ________________
Minimal fire hazard. Large quantities may cause risk of
dust explosion.
Flash Point (Method Used): Not available.
Flammable Limits
Lower Explosive Limit: 60 g/m
Upper Explosive Limit: Not available.
Auto-Ignition Temperature: Not available.
Explosion Data
Sensitivity to Mechanical Impact: Not available.
Sensitivity to Static Discharge: Not available.
Extinguishing Media: Dry chemicals, CO
or foam.
Special Fire Fighting Procedures: Do not use
methods that may create a dust cloud, such as high
7 - English
O=1): 1.15.
2
2
.
, water spray
2