GE Monogram ZBD6605 Owner's Manual page 24

Before You Call For Service
( h_f's Washer
Questions?
Use this
prob&m
sol_gI"
PROBLEM POSSIBLE CAUSE WHAT TO DO
Black or gray marks
on dishes
Dishes do not dry
Chef's Washer won't start
All cycle status indicators
flashing or beeping every
30 seconds (oil ZBD6905,
ZBD 7005 and ZBD 7105)
Motor starts but water
doesn't enter Chef's
Washer (flashing POTS
LIGHT) (on models
ZBD 6905, ZBD 7005
and ZBD 7105)
Program taking too
long or not advancing
properly
Ahuninunl utensils have
rubbed against dishes
HEAT/SMART D RY
not selected
Rinse agent dispenser
is empty
Chef's _\_sher is paused
i,ow inlet water
• Remove marks with a mild, ab*vasive cleane*:
• Depending on model, select HE_T D RY
or SMART DR*d
• Check the rinse agent dispense*;
• To restart the wash cycle, press the selected
wash button.
• Rml tap until water is hot prior to starting
Chef's h_sher cycle.
• Assure inlet water tempe*zmu'e is at
least 120°E
• Depending on your model, select }\_ATER
TEMP HIGH & HEAT DRY or }\_ATER
TEMP SANI and HEkT DRY options.
Door not properly closed • Press door until it clicks shut.
Door opened during cycle • Reqatch do(n: Wait a tew minutes; Chef's
when water is hot _'\_sher will restart automatically.
Child I,ockout mode • Press and hold desired button fi)r two
is selected seconds. See Child I,ockout mode section
fi)r models ZBD6905, ZBD 7005 and ZBD 7105.
Power supply not connected • Check that Chef's Washer is plugged in and
switch is on.
Door not properly closed • Press door until it clicks shut.
Chef's }\hsher is paused • To restart the wash cycle, press the selected
wash button.
_¢\hter
supply
\_flve
turned off
• Open
water
supply \Mve.
ix)w inlet x_zlter tempe*vmu'e • Rml tap until water is hot prior to starting
Chef's }\_sher cycle.
• Allow time to heat water (up to one hour),
• Check inlet water teml)e*_mu'e.
• Connect to hot water
supply
24