GE JGB900 Owner's Manual & Installation Instructions page 33

Usea sewing needle or twist-tie
to unclog flTesmall hole in flTe
burner head.
Burner Caps and Heads
NOTE: Before removing the burner caps
and heads, remember their sl_e and location.
Replace them in the same location after
cleaning.
Burner caps
I,ifl off when cool. _sh bm'ner caps
in hot, soap] water and rinse with clean
water. You ma_, scorn" with a
I)lasfic scotwing,
pad to remoxe burned-on food particles.
Burner heads
For proper ignition, make sure the
small hole in the section that fits oxer the
electrode is kept open. A sewing needle
or wire twist-tie works well to tmclog it.
The slits in the burner hea& must be kept clean
atall, t, l mes
Clogged or dirty brinier ports or electrodes
will not allow fl_e brinier to operate properl):
An) spill
on or arotmd
an electrode must
be carefifllv cleaned. Take care to not hit an
electrode with anything hard or it could
be damaged.
You should clean the bm'ner caps and
bm'ner heads routinely, especiall) after bad
spillox e_, which could clog the oi)enings,
in the bm'ner heads. Lift offwhen cool.
To remove burned-on fi)od,
soak
the
burner heads in a solution of mild liquid
detergent and hot water for 20-30 minutes.
FoF illoi'e
SttlbboFIl staills, rise a toothbrush.
After cleaning
Before putting the burner caps and heads
back, shake out excess water and then (h_'
them thoroughly
by setting
in a warm oven
for 30 minutes.
NOTE" Donot usesteel woolorscouring powders
tocleantheburners. T his candamage theburners
andelectrically shorttheelectrodes.
ge.com
Replacement
Replace burner heads oxer the electrodes
on tile cooktop, in the correct locations
accorcfing to their size.
2!!,
Make sure the slot in the burner head is
positioned over tile electrode.
Replace the matching size caps onto
tile heads.
Medium cap Smallcap
iiO •
i_i I ii i
Frontof range
Largecap Extralargecap
Make sm'e that the heads and caps are
replaced in the correct locations.
33