How To Use; Handle Release Pedal; On/Off Switch; To Transport - Hoover FloorMATE Owner's Manual

1
2
13
15
4
17
14 12
18
17
The assembled cleaner will look like
this drawing,
1. Hand grip
2. Solution trigger: squeeze to
release clean solution,
3. Brush control switch: Turns
brushes ON for wet cleaning and
OFF for wet pickup and dry vacu-
uming,
4. Clean solution tank release
5. Clean solution tank cap/
measuring cup
6. Clean solution tank
7. ON/OFF switch
8. Recovery tank lid and filter
9. Recovery tank release
10. Recovery tank: Collects dry
debris as well as dirty cleaning
solution,
11. Wet/Dry pedam: Press pedal to
change between wet and dry
cleaning,
12. WettDry indBcators: Shows
either wet or dry cleaning usage,
13. NozzJe release buttons:
Release nozzle for easy clean-up,
14. Brush remease buttons: Remove
brushes for easy clean-up,
15. Nozzle
16. Squeegee
17. Handle release peda_
18. Cord hooks: Top hook rotates
for quick cord release,
19. Carrying handle
20. Soft4read wheels
This cleaner is intended for house-
hold use.
Operate cleaner only at voltage
specified on data plate on back of
cleaner,
Plug cleaner into a properly
grounded outlet.
A
Handle Remease Peda_
Step on pedal (A) to lower handle to
operating position, Handle does not
lock into a single position but "floats"
to allow convenient operation,
ON/OFF Switch
Push switch (B) up to turn cleaner on,
Push switch down to turn cleaner off,
To transport
To move your cleaner from room to
room, put handle in upright position;
tilt cleaner back on rear wheels and
push forward,
Condnued -4_ 5