Panasonic SC-BT300 Operating Instructions Manual page 13

Radio antenna connections
Main unit
• Keep loose antenna cables away from other wires and cables.
FM indoor antenna (included)
Affix this end of the antenna
where reception is best.
Main unit
75_
FM ANT
==1
AM loop antenna (included)
Stand the antenna up on its base.
Place the antenna where reception is best.
White
Red
/_Black
Push!
J
Use a Phillips-head
screwdriver, etc.
(not included)
® Do not screw too tightly.
1
Use outdoor antenna if FM/AM radio reception is poor.
• Disconnect the antenna when the unit is not in use.
• Do not use the outdoor antenna during an electrical storm.
FM outdoor antenna
[Using a TV antenna (not included)]
The antenna should be installed by a
competent technician.
I"
i
N
AM outdoor antenna
J [Using a vinyl wire (not included)]
Run a piece of vinyl wire horizontally
I_i across a window or other convenient
5 rn to 12 m location.
(16 ft to 39 ft)
75_1 LOOP EXT _
AM ANT
75 _2 coaxial cable* FMANT
LOOP ANT G!_
L_. !not_i_ncluded). .............. :
Antenna plug (not included) ............
* Rework your outdoor antenna's 75 _2coaxial cable as follows.
Main unit
Leave the AM loop
antenna connected.
(_ Remove a piece of the
outer vinyl insulator.
(_ install the coaxial cable.
Clamp the cable conductor,
and wind it on so that it does
not contact anything else.
10 mm (W32")
•
_ Peel back
10 mm (W32")
$
\
7 mm (_/32") Clamp with pliers
(_ Carefully pull the tabs
apart to remove the cover.
(_) Attach the cover.
RQT9371