Ethernet (Wired Network Only); Setup Wizard (Mfc-7840W Wireless Network Only) - Brother MFC 7345N - Laser Multifunction Center User Manual

e
Press a or b to choose IPv6.
Press OK.
f
Press a or b to choose On or Off.
Press OK.
g
Press Stop/Exit.
Note
After you choose IPv6 On, this setting will be applied to both the wired and wireless LAN interface.

Ethernet (wired network only)

Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a
Press Menu.
b
Press a or b to choose LAN.
Press OK.
c
Press a or b to choose Wired.
Press OK.
d
Press a or b to choose Ethernet.
Press OK.
e
Press a or b to choose Auto, 100B-FD, 100B-HD, 10B-FD or 10B-HD.
Press OK.
f
Press Stop/Exit.

Setup Wizard (MFC-7840W wireless network only)

The Setup Wizard guides you through the wireless network configuration. For more information, see the
Quick Setup Guide or Network User's Guide on the CD-ROM we have provided with the machine.
Control panel setup
3
3
3
25