Asus P8H67 User Manual page 39

3. Intel H67 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1/2 [gray])
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
P8H67
P8H67 Intel
®
• These connectors are set to [AHCI Mode] by default. If you intend to create a Serial ATA
RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID Mode].
See section 2.5.4 SATA Configuration for details.
• Before creating a RAID set, refer to the RAID Supplementary Guide included in the
folder named Manual in the support DVD.
• You must install Windows
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if
you are using Windows
• When using hot-plug and NCQ, set the SATA Mode item in the BIOS to [AHCI Mode].
See section 2.5.4 SATA Configuration for details.
4. Serial port connectors (10-1 pin COM1)
The connector is for a serial (COM) port. Connect the serial port module cable to the
connector, then install the module to a slot opening at the back of the system chassis.
The serial port bracket (COM1) is purchased separately.
P8H67
P8H67 Serial port (COM1) connector
ASUS P8H67
RSATA_TXN2
RSATA_RXP2
RSATA_RXN2
RSATA_TXN1
RSATA_RXP1
RSATA_RXN1
SATA 6.0Gb/s connectors
XP Service Pack 2 or later version before using Serial ATA
®
XP SP2 or later version.
®
SATA6G_2
GND
RSATA_TXP2
GND
GND
SATA6G_1
GND
RSATA_TXP1
GND
GND
COM1
PIN 1
1-27