Internal Connectors - Asus P5Q SE2 User Manual

Audio 2, 4, 6, or 8-channel configuration
Port
Light Blue
Lime
Pink
Orange
Black
Gray
9.. USB.2.0.ports.1.and.2. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
10. USB.2.0.ports.3.and.4. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
11. Coaxial.S/PDIF.Out.port..This port connects an external audio output device via a
coaxial S/PDIF cable.
12.. USB.2.0.ports.5.and.6. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
13.. PS/2.keyboard.port.(purple). This port is for a PS/2 keyboard.
1.10.2. Internal.connectors
1.. Floppy.disk.drive.connector.(34-1.pin.FLOPPY)
This connector is for the floppy disk drive (FDD) signal cable. Insert one end of the
cable to this connector, then connect the other end to the signal connector at the back
of the floppy disk drive.
• Pin 5 on the connector is removed to prevent incorrect cable connection when using a
• The FDD cable is purchased separately.
P5Q SE2 Floppy disk drive connector
1-20
Headset.
4-channel
2-channel
Line In Line In
Line Out Front Speaker Out
Mic In Mic In
–
– Rear Speaker Out
–
FDD cable with a covered Pin 5.
P5Q SE2
6-channel
Line In
Front Speaker Out
Mic In
– Center/Subwoofer
Rear Speaker Ou
–
FLOPPY
PIN1
NOTE:Orient the red markings
on the floppy ribbon cable to PIN 1.
8-channel
Line In
Front Speaker Out
Mic In
Center/Subwoofer
Rear Speaker Out
– Side Speaker Out
Chapter 1: Product introduction