Intel Desktop Board D845EBG2/D845EPT2 Technical Product Specification
1.11 LAN Subsystem (Optional)
The Network Interface Controller subsystem consists of the ICH4 (with integrated LAN Media
Access Controller) and a physical layer interface device. Features of the LAN subsystem include:
•
PCI Bus Master interface
•
CSMA/CD Protocol Engine
•
Serial CSMA/CD unit interface that supports the 82562ET (10/100 Mbit/sec Ethernet) on the
CNR bus
•
PCI Power Management
Supports ACPI technology
Supports LAN wake capabilities
1.11.1 Intel
®
82562ET Platform LAN Connect Device
The Intel 82562ET component provides an interface to the back panel RJ-45 connector with
integrated LEDs. This physical interface may alternately be provided through the CNR connector.
The Intel 82562ET provides the following functions:
•
Basic 10/100 Ethernet LAN connectivity
•
Supports RJ-45 connector with status indicator LEDs on the back panel
•
Full device driver compatibility
•
ACPI support
•
Programmable transit threshold
•
Configuration EEPROM that contains the MAC address
1.11.2 RJ-45 LAN Connector with Integrated LEDs
Two LEDs are built into the RJ-45 LAN connector. Table 6 describes the LED states when the
Desktop Board is powered up and the LAN subsystem is operating.
Table 6.
LAN Connector LED States
LED Color
LED State
Green
Off
On
Yellow
Off
On (steady state)
On (brighter and pulsing)
32
Condition
10 Mbit/sec data rate is selected.
100 Mbit/sec data rate is selected.
LAN link is not established.
LAN link is established.
The computer is communicating with another computer on
the LAN.