Emerson OCX 8800 Instruction Manual page 97

Instruction Manual
IM-106-880, Rev 1.0
January 2007
Figure 7-21. Removal/
Installation of EMI Filter
Remove Solenoid Valves
1. Disconnect solenoid leads from mating terminal connector.
2. Remove top nut of solenoid valve (15 or 16, Figure 7-20).
3. Remove the solenoid coil assembly and washer.
4. Unthread and remove solenoid valve base.
Remove EMI Filter and Terminal Block
1. Disconnect EMI filter wiring (Figure 7-21) at terminal block (3).
2. Disconnect EMI filter wiring at AC power input terminal block on
electronic stack.
3. Unbolt and remove EMI filter (1) from electronic stack.
4. Remove ground wire (2) from terminal block (3).
5. Unbolt and remove terminal block (3) from electronic stack.
Brown
Blue
Green
Green
3
OCX 8800
Blue
Brown
Green
1
2
7-27