Electrolux EWS 105410 A User Manual page 16

16 electrolux
Problem
The appliance does not
fill with water.
The appliance does not
drain the water.
The spin phase does
not operate.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
Possible cause
The programme knob is not in
the correct position.
The delay start is set.
It is available only for models
with the Delay start.
The water tap is closed.
The water inlet hose is dam-
aged.
The filter in the water inlet
hose is blocked .
The water tap is blocked or
there is limescale on it.
The connection of the water
inlet hose is not correct.
The water pressure is too low.
The water drain hose is dam-
aged.
The filter of the drain pump is
blocked.
The connection of the water
drain hose is not correct.
A washing programme without
the drain phase is set.
The function Rinse Hold is on.
The spin phase is off.
The filter of the drain pump is
blocked.
Balance problems with the
laundry load.
Leakages from the couplings
of the water hoses.
Leakages from the drain
pump.
The water drain hose is dam-
aged.
The washing programme is in
operation.
There is water in the drum.
Incorrect level of the appli-
ance.
You did not remove the pack-
aging and/or the transit bolts.
The load is very small.
Possible solution
Turn the programme knob in the correct
position.
To start immediately the programme,
cancel the delay start.
Open the water tap.
Make sure that the water inlet hose has
no damages.
Clean the filter. Refer to 'Care and clean-
ing'.
Clean the water tap.
Make sure that the connection is cor-
rect.
Contact your local water authority.
Make sure that the water drain hose has
no damages.
Clean the filter of the drain pump. Refer
to 'Care and cleaning'.
Make sure that the connection is cor-
rect.
Set the drain programme.
Set the drain programme.
Set the spin programme.
Clean the filter of the drain pump. Refer
to 'Care and cleaning'.
Adjust manually the items in the tub and
start the spin phase again.
Make sure that the couplings are tight.
Make sure that the drain pump filter is
tight.
Make sure that the water inlet hose has
no damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer
to 'Installation'.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
Add more laundry in the drum.