Table of Contents
Advertisement
30 electrolux
3.
Remove right polystyrene part by pulling
it. Inside this part there is a bottle of dis-
tilled water for steam programme purpo-
ses.
4.
Remove left polystyrene part by pulling it.
Inside this part there is a canister for filling
distilled water tank for steam programme
purposes.
Electrical connection
Details on mains voltage, type of current and
the fuses required should be taken from the
type plate. The type plate is fitted near the
loading aperture (see "Product description"
chapter).
Connect the machine to an earthed
socket, in accordance with current wir-
ing regulations.
Warning! The manufacturer declines
any responsibility for damage or
injury through failure to comply with
the above safety precautions.
Should the appliance power supply
cable need to be replaced, this must
be carried out by our Service Center.
Warning! The plug must be
accessible after installing the
machine.
Changing door stop
Warning! Before changing the door
stop, disconnect the mains plug.
1.
A
A
Open loading door.
2. Unscrew hinge A from the front of the
machine and take off the loading door.
3. Remove cover plates B . To do this, in-
sert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block C from the
snap-on fixture, take out and re-insert on
the other side having rotated the block
through 180°.
5. Unscrew hinge A from the loading door,
rotate through 180°, re-insert on the op-
posite side and screw down.
6. Re-insert cover plates B on the opposite
site having first rotated them through
180°.
7.
D
E
E
D
Unscrew cover plates D from the front of
the machine, rotate through 180°, screw
on the opposite side.
8. Unscrew door lock E , push down slight-
ly and remove from the front of the ma-
chine.
9. Press snap-in button F in and down,
press cover down slightly and remove
from front of the machine.
10. Change door lock E over to the opposite
side, screw down the door interlock.
11. On the other side, insert cover F and al-
low snap-in button to lock into place.
12. Insert loading door and hinges into re-
cesses on the front of the machine and
screw down.
B
C
B
F
F
Advertisement
Table of Contents
