Electrolux TK SL5 E User Manual page 23

Using the attached canister to filter: Pour
the water out of the container straight
through the filter at the top of the canis-
ter.
Cleaning heat exchanger
If the message: Please clean the condenser
is shown in the display, the heat exchanger
needs to be cleaned.
Caution! Operating when the heat
exchanger is blocked with fluff can
damage the dryer. This also increases
energy consumption.
1. Open door.
2. Open door in plinth. To do this, press the
release button on the bottom of the door
aperture and open the door in the plinth
to the left.
3. Clean fluff from the inside of the door and
the heat exchanger front chamber. Wipe
the door seal with a damp cloth.
4. Turn both lock washers inwards.
5. Use the handle to pull the heat exchanger
out of the base and carry it horizontally to
prevent any remaining water from spilling.
6. To empty the heat exchanger, hold verti-
cally over a washing-up bowl.
Caution! Do not use sharp objects to
clean. The heat exchanger could
develop leaks.
7. Clean heat exchanger.
It is best to use a brush or to rinse thor-
oughly with a hand-held shower.
8. Replace heat exchanger and lock into
place (turn both lock washers outwards
until they snap into place).
9. Close door in plinth.
Caution! Never operate the dryer
without the heat exchanger.
Cleaning the water recirculation valve/
filter
If the message Please clean the water recir-
culation filter is shown in the display, the re-
circulation filter needs to be cleaned. The
valve/filter is placed behind the tank handle -
see chapter "Product description".
1. Pull out completely the drawer containing
condensed water container.
2. Turn the valve/filter to the OFF position.
3. Wait a few seconds to allow the correct
emptying of the valve/filter.
4. Pull out the valve/filter.
5. Clean the valve/filter under warm water.
6. Re-insert the valve/filter.
electrolux 23