Electrolux TK SL5 E User Manual page 18

18 electrolux
3. Press repeatedly Option button to select
proper option. Selection is marked by
rectangular border.
4. Press OK button to activate it. Suitable
icon should appear on the right side of the
screen.
To deselect an option follow the same
steps. Option icon should disappear.
DELICATE
For especially gentle drying of sensitive fab-
rics with the care label:
ture-sensitive textiles (e.g. acrylic, viscose).
Programme is executed with reduced heat.
DELICATE is only suitable for use with loads
of up to 3kg.
When the option is active, the DELICATE
icon is on.
SENSITIVE
For gentle drying of fabrics that are frequently
worn. Programme starts on full heat setting,
which is then reduced as the programme
progresses to be kind to the washing.
When the option is active, the SENSITIVE
icon is on.
LONG ANTICREASE
A 90 minute anti-crease phase is set. The
display now shows the long anti-crease
icon. If this additional option is selected, the
anti-crease phase (30 min.) at the end of the
drying cycle is lengthened by 60 minutes.
The laundry can be removed at any time dur-
ing the anti-crease phase.
BUZZER
The appliance is supplied with the BUZZER
function deactivated. The button is used to
switch the function on or off. When the func-
tion is active, the BUZZER symbol appears in
the display.
The buzzer sounds or plays a tune during:
– cycle end
– anti-crease phase and when phase starts
or ends
– cycle interruption by a warning
– alarm
CHILD LOCK
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child safety device locks all
buttons and the programme knob. The child
safety device can be deactivated by holding
and for tempera-
down the Option and OK buttons simultane-
ously for 5 seconds.
– Before programme is started: appliance
cannot be used
– After programme is started: programme in
operation cannot be changed
The child lock icon appears in the display
to indicate that the child lock is activated. The
child lock is not deactivated once the pro-
gramme comes to an end. If you want to set
a new programme, you must first deactivate
the child lock.
SPIN SPEED
If the washing in the washing machine was
initially drained prior to the drying cycle, the
dryer can be set according to the spin speed
of the initial drainage procedure. The higher
the spin speed was, the shorter the pro-
gramme length for the drying cycle.
Activate the SPIN SPEED option and then
number of times press Option button until the
desired spin speed of the initial drainage is
displayed. No value is shown if no spin speed
is selected.
In certain programmes the spin speed has
not effect (time controlled cycles), its selec-
tion can be not selectable and only three
dashes are visualized. Available selections:
from 800 to 1800 rpm's in 100 rpm's inter-
vals.
The maximum value depends by selected
program, the minimum is always 800 rpm
For those programs where the spin speed
has no effect (time controlled cycles), the se-
lection is not allowed and three dashes "- -
-" are displayed that has the meaning of not
set or unknown.
The user interface always remembers last
spin selection, and proposes it as default for
all new selected programs. If memorized spin
speed is greater than maximum allowed val-
ue it will be automatically reduced to max
spin speed available for the selected pro-
gram.
Selecting Zeitwahl (TIME)
To select the programme duration after set-
ting the Zeitprogramme (TIMED PRO-
GRAMME) programme. You can select a
programme duration from 10 minutes to 3
hours in 10-minute steps.
1. Turn the programme knob to the Zeit-
programme (TIMED PROGRAMME). The