Table of Contents
Advertisement
14 electrolux
down the Option and OK buttons simultane-
ously for 5 seconds.
– Before programme is started: appliance
cannot be used
– After programme is started: programme in
operation cannot be changed
The child lock
icon appears in the display
to indicate that the child lock is activated. The
child lock is not deactivated once the pro-
gramme comes to an end. If you want to set
a new programme, you must first deactivate
the child lock.
SPIN SPEED
If the washing in the washing machine was
initially drained prior to the ProSteam cycle,
the dryer can be set according to the spin
speed of the initial drainage procedure. The
higher the spin speed was, the shorter the
programme length for the drying cycle.
Activate the SPIN SPEED option and then
number of times press Option button until the
desired spin speed of the initial drainage is
displayed. No value is shown if no spin speed
is selected.
In certain programmes the spin speed has
not effect (time controlled cycles), its selec-
tion can be not selectable and only three
dashes are visualized. Available selections:
from 800 to 1800 rpm's in 100 rpm's inter-
vals.
The maximum value depends by selected
program, the minimum is always 800 rpm
For those programs where the spin speed
has no effect (time controlled cycles), the se-
lection is not allowed and three dashes "- -
-" are displayed that has the meaning of not
set or unknown.
The user interface always remembers last
spin selection, and proposes it as default for
all new selected programs. If memorized spin
speed is greater than maximum allowed val-
ue it will be automatically reduced to max
spin speed available for the selected pro-
gram.
Setting Zeitvorwahl (DELAY START)
function
With the Zeitvorwahl (DELAY
START) button, you can delay the
start of a ProSteam programme by
between 30 minutes and a maximum
of 20 hours.
1. Select the programme and additional
functions/options if necessary.
2. Press the Zeitvorwahl (DELAY START)
button as many times as necessary.
During selection, END TIME of the cycle
increases in the display and delay icon
is on.
If you reach 20 hours of start delay
and you press the button again, the
time delay is cancelled and delay
icon disappears.
3. To activate the delay timer, press the
Start / Pause button. The amount of time
remaining until the programme is set to
start is continuously displayed (e.g. 5:00
hours, 4:59... 0:30 minutes etc).
The message Delay Start and delay icon
is on.
Starting the ProSteam programme
COTTON SHIRTS
Press START to run
programme.
MED
---
Press the Start / Pause button. The pro-
gramme starts.
The progress bar and the name of currently
performed phase, above it, show stage of the
cycle.
With wet laundry, after a few minutes the ap-
pliance will show the correct programme du-
ration for the ProSteam programme includ-
ing the preceding drying programme.
As soon as the right level of dryness is
reached, the ProSteam programme will start
automatically. Alternately Steam Treatment
and Steam Injection phases names are dis-
played.
Important! During the steam phases that
form part of the ProSteam programme
and also the anti-crease phase the
loading door cannot be opened.
Risk of burns!
0:21
13:22
---
Advertisement
Table of Contents
