Remote Control Codes For Onkyo Components Connected Via Ri; Resetting The Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Onkyo HT-S5600 Owner's Manual

Remote Control Codes for Onkyo
Components Connected via RI
Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with
an cable and an analog audio cable (RCA).
See "Connecting Onkyo RI Components" for details
(➔ page 16).
2
Enter the appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
42157:
Onkyo cassette tape deck with
81993:
Onkyo Dock with
3
Press the REMOTE MODE button, point the
remote controller at the AV receiver, and operate
the component.
Controlling Onkyo components without
If you want to control an Onkyo component by pointing the
remote controller directly at it, or you want to control an
Onkyo component that's not connected via
following remote control codes:
30627:
Onkyo DVD player without
71817:
Onkyo CD player without
32900/33100/33500:
Onkyo Blu-ray Disc player
32901/33104/33504:
Onkyo HD DVD player
70868:
Onkyo MD recorder without
71323:
Onkyo CD recorder without
82990:
Onkyo Dock without
are

Resetting the REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default
remote control code.
1
While holding down the REMOTE MODE button
that you want to reset, press and hold down HOME
until the remote indicator lights (about 3 seconds).
2
Within 30 seconds, press the REMOTE MODE
button again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each REMOTE MODE button is preprogrammed
with a remote control code. When a button is reset, its
preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down RECEIVER, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
, use the
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.
En-54

Controlling Other Components

Controlling Other Components
By pressing the REMOTE MODE button that's been
programmed with the remote control code for your
component, you can control your component as described
below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ page 53).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the
some models). The TV must be able to receive remote
control commands via and be connected to the
AV receiver via HDMI. If controlling your TV via
doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
11807/13100/13500:
TV with
Controlling Apple TV
By programming the supplied remote controller with the
appropriate remote control code, you can use it to operate
your Apple TV.
Use the following remote control codes:
02615:
Apple TV
(limited to
*1