Table of Contents
Advertisement
MPI CARD SLOT / PPVCARD INSTALLATION
The MPI card is equipped
with an RF jack for antenna/cable
signal source connection.
The MPI card slot is also available for installing
a PPV (Pay-Per-View) card.
MPI Card Removal/PPV
Card Installation
1. Remove the two MPI card retainer screws.
2. Pull out current MPI card far enough so that the RF cable can be detached
from the old card.
3. Detach RF cable.
4. Place new PPV card into slot and slide it in far enough to reconnect
RF cable.
5. Insert card all the way into the slot making sure it is fully seated into back plane connector.
6. Replace the two card retainer screws.
-0
_o
m
_o
©
z
RF CABLE
RF cable needs to be
disconnected
to remove
the current card.
M.P.I.
Card Slot
19
Advertisement
Table of Contents
Troubleshooting
