Cutting Large Sheets; Maintenance; Tool Lubrication - Dremel 670 Operating/Safety Instructions Manual

5716 Dremel 2.625x4.25

CUTTING LARGE SHEETS

Large sheets and long boards sag or bend,
depending on support. If you attempt to cut
without leveling and properly supporting the
piece, the blade will tend to bind, causing
KICKBACK and extra load on the rotary tool. (Fig. 1)
Figure1
Kickback
Support the panel or board close to the cut, as
shown in (Fig. 2). Be sure that you cut through the
sheet or board only and not the table or work
bench. The two-by-fours used to raise and support
the work should be positioned so that the
broadest sides support the work and rest on the
table or bench. Do not support the work with the
narrow sides as this is an unsteady arrangement.
If the sheet or board to be cut is too large for a
table or work bench, use the supporting two-by-
fours on the floor and secure.
18
6/18/02 10:31 AM Page 18
Figure 2
Feed Direction
WARNING
!
personnel may result in misplacing of internal
components which could cause serious
hazard. We recommend that all tool service be
performed by a Dremel Service Facility.
Your saw attachment has been properly lubricated
and is ready to use.

Maintenance

SERVICE
Preventive maintenance
performed by unauthorized

TOOL LUBRICATION

19