Dixon ZTR 3000 SERIES Operator's Manual page 12

CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:
Page 12
SPECIFICATIONS
Model ZTR 3304
Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
11 GA stamped steel construction.
Single 30" cut blade.
Cut height approximately 1" to 4" via 7 position lift handle.
Mechanical; hand lever engagement.
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
14.5 HP Briggs & Stratton I/C Quiet, 4-Cycle, Single Cylinder, Air-Cooled,
Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced, Laminated
Shroud
Electric by key switch operation with safety interlocks on parking brake and
blade drive.
Front 11 X 4.00-5 ribbed tread.
Rear 16 X 6.50 X 8 Turf Trac R/S tread.
Front 16-21 PSI
Rear 8-14 PSI
Fuel 2.0 gallons total.
Engine 1.25 quarts oil.
Width 32.5" outside rear wheel measurement.
Height 32.0" to top edge of seat.
Length 65.5" hitch tab to front bumper.
Weight 440 lbs.
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.