Asko D5644 User Manual page 16

Problem
The dishwasher does not start.
1 minute appears on the display.
Water remains in the dishwasher above the
filters.
Bad odor in dishwasher.
The dishes are not dry enough.
Cannot close door.
16
Possible causes
The Start/Stop start button has been pressed
for too short a time.
The door is not properly closed.
A fuse/circuit breaker has been tripped.
The plug is not plugged into the power outlet.
The water supply valve is turned off.
Overflow/leaks.
A whirring sound (the drain pump) is heard
from the dishwasher and does not stop when
the power is cut with the On/Left-on mode
button.
Check that the Delayed start option has not
been selected.
The program is taking longer than estimated.
Blocked drain hose.
Kink in drain hose.
The filters are blocked.
Debris in the drain pump.
Dirt around the seals and in corners.
Low temperature programs have been select-
ed for a prolonged period.
Drying power too low.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage is set
too low.
The baskets are not correctly positioned.
Customer Care Center 1-800-898-1879
www.askousa.com
Action
Press and hold Start/Stop until the display
shows (the door open symbol). This
indicates that the dishwasher is ready to start.
Check.
Check.
Check.
Check.
Check.
Turn off the water supply valve. Pull out the
plug and call the Customer Care Center.
Press and hold Start/Stop for three seconds
if you want to cancel the Delayed start option.
None. Next time the program is run, the
corrected time will be displayed.
Loosen the drain hose from where it termi-
nates. Check that no debris has clogged the
hose. Is the cone-shaped part of the drain
boot cut to the maximum size of the fitting
where it attaches?
Check that the hose is free from kinks and
sharp bends.
Clean the coarse and fine filters.
Clean the drain pump. See the section Care
and maintenance instructions.
Clean with dish brush and low foaming clean-
er.
Run a program with a higher temperature
about once a month.
Activate the Long dry option.
Fully load the dishwasher.
Top up with rinse add or increase the rinse
aid dosage. See the sections Before washing
for the first time and Settings.
Open the door a little once the program has
finished.
Check that the baskets are correctly posi-
tioned horizontally, and that the middle bas-
ket's water connector is in line with its spray
pipe.
Check that the dishes are not blocking the
baskets from sliding properly into place.