Desa E32L Owner's Operation And Installation Manual page 22

3. If upper back cabinet ribbons need re-
placing, remove 4 Phillips screws holding
corresponding bottom and top hanger
brackets (see Figure 37, page 21).
4. Remove any loose or damaged ribbon
material.
5. Cut an 18" strip of reflective ribbon and
position top end about an inch above top
bracket position (see Figure 37, page 21).
Note: Ribbon material should be ap-
plied with reflective side up, should not
be twisted or tangled, and should hang
slightly loose to allow free movement.
If additional parts are required, see Re-
placement Parts, page 23.
6. Replace top hanger bracket using 2 Phil-
lips screws removed in step 2 and tighten
until reflective ribbon is held in place.
7. Replace bottom hanger bracket using 2
remaining Phillips screws to secure lower
end of reflective ribbon.
8. If replacing reflective ribbons located in
base, remove screws and washers at
damaged ends of ribbon.
9. Cut a 9" long strip of ribbon and apply across
each ribbon support bracket with shiny side
facing up (see Figure 37, page 21).
10. Secure ribbon to brackets by replacing
each washer at end of the ribbon and re-
threading screws through the ribbon into
each hole located on support brackets.
11. If replacing top reflective ribbons on base
cover, cut a 3" section of ribbon and split
down the middle. With shiny side up, attach
with cellophane tape into rear edge of base
cover opening (see Figure 37, page 21).
12. Readjust flame pennants (if removed). See
Servicing Flame Pennants, page 19.
13. Reassemble imager. See Accessing
Imaging Unit, page 18.
14. Center log bed over opening between
viewing panel screen and grate.
15. Cover remaining hearth area with 1/4" of
lava rock (provided), if desired.

MAINTENANCE
Continued
CLEANING vIEWING SCREEN
Clean viewing screen with an alcohol based,
nonabrasive, residue free cleaner (premoist-
ened hand wipes are ideal). Do not use glass
cleaners with ammonium, abrasive scrubs or
degreaser solvents of any kind.
ACCESSING IMAGING UNIT FOR
REPLACEMENT
The imaging unit can be removed from inside
the firebox for servicing or replacement:
1. Follow steps under Accessing Imaging
2. Remove 4 hex screws on lower louver
3. Rotate top edge of lower frame rail inward
4. Slide entire imaging unit forward and lift
Note: An additional 3 feet of harness is tucked
behind imager to permit removal without dis-
connecting any control wiring.
Lower
Frame
Rail
Lower Panel
Figure 38 - Removing Lower Louver
www.desatech.com
Unit, on page 18.
panel and detach louver assembly from
front face (see Figure 38).
and lift upward until locking tabs detach
from front face (see Figure 38).
out through front opening (see Figure 39,
page 23).
Lower Frame
Rail
Locking Tab
Panel and Frame Rail
111076-01F