Desa E32L Owner's Operation And Installation Manual page 11

6. Slide blower mount towards rear of firebox
until locking tabs line up with notched
openings and lower mount down and
away (see Figure 18).
7. Remove blower/heater assembly with 4
screws from packaging. Blower is pre-
wired for convenience.
8. Align blower assembly over hole pattern on
blower mount and attach with 4 pan head
screws provided (see Figures 19 and 20).
9. With discharge pointing towards you, guide
assembled blower mount into fireplace
and center rear mounting flanges between
standoff brackets at rear of the fireplace.
10. Lift blower mount up and position 4 locking
tabs through notched openings in firebox
top. Slide assembly forward until locked
into position.
11. Remove control panel knockout plug lo-
cated in heater switch position by pressing
locking tabs and pushing plug out through
front of panel (see Figure 21).
12. Firmly insert red power switch into open
mount location with "ON" (I) indicator
positioned on top.
Notches for Control Cover
Control
Blower
Panel
Mount
Screws
Control
Cover
Screws
Figure 18 - Disassembling Blower Mount
111076-01F
ACCESSORy INSTALLATION
Continued
Blower Mount
Notch (1 of 4)
Hex.
Screws
Control
Cover
www.desatech.com
Harness
Strap
Mounting
Screws
Figure 19 - Mounting Heater/Blower
Heater/
Blower
Assembly
Figure 20 - Mounting Alternate Heater/
Knockout Plug
Remove to
Install Power
Switch
Figure 21 - Installing Heater Power Switch
Heater/
Blower
Assembly
Blower
Mount
Mounting
Screws
Blower
Mount
Blower
Power
Switch
11