eMachines E4264 Reference Manual page 47

www.emachines.com
4
Loosen the four captive screws (these screws cannot be
removed) that secure the heat sink and fan assembly
to the system board, then remove the assembly and
place it on a stable surface with the flat surface of the
heat sink (the side with the thermal grease) up.
5
Push the processor release lever down, lift it completely
up, then lift the processor retention bracket.
6
Remove the processor from the system board.
7
Install the new processor onto the system board. Make
sure that Pin 1 on the processor (indicated by the
silk-screened arrow on the corner of the processor)
aligns with Pin 1 on the processor socket (indicated by
the absence of a pin hole in the processor socket), then
return the retention bracket and lever to their locked
position.
Screws (only one shown)
41