Setting Up Remote Siren - X-10 POWERHOUSE PS561 Owner's Manual

POWERHORN REMOTE SIREN
SETTING UP THE POWERHORN
The
POWERHORN
siren responds to signals transmitted
by the Console (over house wiring).
When the alarm trips, the Console's si-
ren sounds and lights flash. After the
lights have flashed on and off about 5
times, the
POWERHORN
sounds for as long as the system is in
alarm and then shuts off about 10 sec-
onds after the alarm resets or is dis-
armed.
Set Housecode and Unit Code dials
1.
on
POWERHORN
and number as the Console.
Plug
2. POWERHORN
AC outlet (not one controlled by a
wall switch).
Remote Powerline
trips. It
to same letter
into a standard
WARNING: The
extremely loud! Do not stand near it
when you trip the alarm. Prolonged
exposure to the 110 decibel output
could cause permanent hearing
damage.
Using the POWERHORN
other X-10 Controllers
In a panic situation, you can trip the
from other types of
POWERHORN
Controllers by either of the following
methods:
Press All Lights On followed by
1.
All Units Off repetitively.
Press the number corresponding to
2.
the Unit Code set on the
then press ON, OFF, ON
HORN,
repetitively.
In both cases the
POWERHORN
after about 5 ON-OFF sequences
trip
and will alter its tone for each ON and
OFF code. The siren will shut off
about 10 seconds after the last key
press.
is
POWERHORN
with
POWER-
will