Table of Contents
Advertisement
INSTALLING THE SYSTEM
LOCATING THE
CONSOLE
Select a location that is central to the
doors and windows you wish to pro-
tect so that all Door/Window Sensors
and Motion Detectors are within range
of the Console. Later, when you are
familiar with the operation of the sys-
tem you should test all the Sensors,
Motion Detectors, and Remote Con-
trols from the locations you intend to
use them. Also, locate the Console
near a phone jack and where it can
easily be seen on a day to day basis so
that it will be noticed if any of the
zone indicators report a problem.
Caution:
place the Console
Do not
where a burglar can easily see it.
SETTING UP THE
CONSOLE
1.
Console into an AC outlet
Plug the
which is not controlled by a wall
switch.
2.
Fully extend the RF antenna
3.
Plug the included phone cord into
the socket on back of Console and
plug the other end into an unused
telephone jack. If you don't have an
unused jack use the included "T"
adapter to plug the Console and
your telephone into the same jack.
4.
Install a 9-volt alkaline battery in
the Console's battery compartment.
5.
Set the Console's Unit Code dial to
the number of the module that you
want to turn on and off from the
HT544, KF574 or the "security" on
and off buttons on the SH624.
6.
Set the Console's Housecode dial to
the same letter as the modules you
want it to control.
7.
Set the Console's INSTALL/RUN
switch to
INSTALL.
8.
The switch on the bottom of the
Console is set for tone, if you don't
have touch-tone service, set it to
pulse. (See note below).
- @ Important: The Console can be set
to call out on either pulse or touch-
tone phone systems but if the friend or
neighbor who you choose to accept
calls from your system does not have
touch-tone service, they will need to
purchase a touch-tone 'beeper."
5
Hide quick links:
Advertisement
Table of Contents
