Security Remote - X-10 Pro 2000 Installer's Manual

Installation

Security Remote

Registering the Security Remote with the Security Console
• Set the code dial on the Security Remote to the same House Code as the
programmed in the Security Console.
Note: The House Code for the Security System is downloadable. The default setting is
House Code A.
• Fit four AAA Alkaline batteries in the battery compartment in the back of the remote.
• Set the slide switch on the Security Console to INSTALL.
• Press ARM on the Security Remote. The console chimes once to confirm that the
keychain has been registered.
• Return the console slide switch to the RUN1 or RUN2 position.
Note: If the remote did not register, remove the label on the front and use a pencil or
other pointed object to press the small CODE button to generate a new random code.
Press ARM again to install the remote.
Testing the Security Remote
• Set the slide switch on the security console to RUN1 or RUN2.
• Press ARM AWAY on the remote. The console chimes once to confirm and the ARM
indicator lights up. Press DISARM.
• Press SECURITY LIGHT ON and OFF to control a light connected to a lamp module
with code dials set to A13 (or other code downloaded during installation).
®
™
Tampa, FL33618
9
Technical Support: 800 832 4003
PRO2000_DR/AB-6/98