Table of Contents
Advertisement
Adjustments and functions (continued)
< AUTO-adjustment
>
The projector will automatically
adjust four items (V POSIT, H POSIT, H PHASE, H SIZE, White level).
When AUTO is selected (the cursor is moved from Manual Operation towards the right) the AUTO Confirm
screen shown below will be displayed.
<
AUTO-adjustment
Confirm Screen >
kE@
INPUTIMAGE OPT
While the AUTO
confirmation
screen is displayed
as illustrated
on the
d
VOLUME
upper right, if you shift the cursor upward and select AUTO, the projector
BRIGHT
CONTRAST
will perform auto-adjustment.
It will become as illustrated
on the lower right.
~;,
m=!
If CANCEL is selected for three seconds, or if the RESET button on either
COLORBAL
R~
B
the unit or the remote control is pressed, the green cursor will return to
the value for the selected item (Manual Operation)
< During AUTO-adjustment
>
a
At the lower right of the screen the word .AUTO>
will flash in green
letters.
When the auto-adjustment
is completed the word AUTO>
will disappear.
The auto-adjustment
of the white level is cancelled by input switching and
AUTO
signal mode change.
I
1
@@
* When start up screen is displayed ("NO INPUT IS DETECTED"
or "SYNC IS OUT OF
RANGE" is displayed),
SETUP menu items other than VOLUME
cannot be set.
. TINT cannot be adjusted with PAL/SECAM
video signal input.
TINT, COLOR and SHARPNESS
cannot be adjusted with an RGB signal input.
. V. POSIT, H. POSIT, H. PHASE and H.SIZE cannot be adjusted with a VIDEO signal input.
. Auto-adjustment
will take about 10 to 15 seconds to complete.
. In some cases auto-adjustment
may not function normally,
depending on the type of
computer to which the unit is connected,
and the signal sent.
. Auto-adjustment
may not perform normally with some images. Do not use with animated
or dark images.
Carry out the auto-adjustment
when the application,
which is activated on the computer,
is
set to the maximum
display.
. After auto-adjustment
the screen may become slightly dark due to the auto-adjustment
of
the signal level.
Auto-adjust
can not be performed
during freeze, during magnify, or during the initial
screen display ("NO INPUT IS DETECTED"
or "S~C
IS OUT OF RANGE").
INPUT
The menu INPUT serves for the selection of input source.
n
~1
ml
Adjustment
Item
Details of adjustment
RGB 1
Selects the RGB 1 terminal.
RGB 2
Selects
the RGB 2 terminal.
VIDEO
Selects
the VIDEO
terminal.
Selects
the video signal systems.
In normal circumstances,
select AUTO.
AUTO
does not
SYSTEM
support N-PAL.
When the picture (Video)
is abnormal
(no
color), selects the input signal
mode
(NTSC,
I
I PAL, SECAM,
NTSC4.43
M-PAL
and N-PAL).
To input N-PAL signals, select N-PAL,
18
Advertisement
Table of Contents
