Canon LV-7297M User Manual page 56

Setting
HDMI setup
This function is only used for HDMI input source.
Image
Select Normal or Enhanced to match the
video range setting of your HDMI Digital
RGB equipment.
Sound
HDMI: When using the HDMI cable,
COMPUTER : When using the DVI-HDMI
The names for the output setting of Digital RGB
vary from equipment to equipment. For details,
refer to the user's manual of your Digital RGB
equipment.
When the black parts of the image are
destroyed or stand out, please switch to
Normal or Enhanced, and then switch the
output type of the HDMI Digital RGB output
equipment.
Power management mode
For reducing power consumption as well
as maintaining the lamp life, the Power
management mode function turns off the
projection lamp when the projector is not
operated for a certain period.
Select one of the following options:
Standby ........ When the lamp has been fully
cooled down, the POWER
indicator changes to green
blinking. In this condition,
the projection lamp will be
turned on if the input signal
is reconnected or any button
on the top control or remote
control unit is pressed.
Exit ...............
When the lamp has been fully
cooled down, the power will
be turned off.
Off ................. Power management mode
function is off.
Timer ............ If the input signal is
interrupted and no button
is pressed for more than 30
seconds, the timer display
with No signal appears. It
starts the countdown until the
lamp is turned off. Use the
Point ▲▼ buttons to set the
Timer (1~30min).
Note:
Factory default is Standby: 5 min.
Direct power on
When this function is set to On, the projector will
be automatically turned on just by connecting
the AC power cord to a wall outlet.
56
select HDMI.
Both video and audio are
transferred and you need
not to connect any additional
cables for audio.
cable, select COMPUTER
and connect the audio cable
to COMPUTER IN termimal.
HDMI setup
Power management mode
Time left before Lamp is off.
Note:
Be sure to turn off the projector properly (see
"Turning Off the Projector" on page 23). If
the projector is turned off in the incorrect
sequence, the Direct power on function will
not work properly.