Preparation For Use; Unpacking And Setup - Emerson Research SmartSet CKD5811 Owner's Manual

Unpacking and Set-up
• Remove the unit from the shipping carton and remove all packing material
from the unit. Please save the carton and packing material if possible in the
event that your unit ever needs to be returned for service. Using the original
carton and packing materials is the only way to protect your unit from damage
in transit.
• Carefully remove any small strips of tape that may have been used to keep the
CD door closed during shipment.
• Press on the CD door in the area marked OPEN/CLOSE to open the door.
Inside the CD compartment you will see a white "dummy CD" transit protection
card. This card prevents the laser pick-up from moving during shipment and it
must be removed before you can load your own CDs. Carefully remove this
transit protection card and discard it.
• Note the serial number on the bottom of your CD clock radio and write this
number in the space provided on Warranty page of this manual.
• Place the unit on a stable, level surface such as a table, desk, shelf, stand, etc,
out of direct sunlight and away from sources of excess heat, dust, vibration,
moisture, or humidity, and convenient to a 120V 60Hz AC outlet.
• Unwind the AC power cord and extend it to its full length. This is important. The
FM antenna is built into the AC power cord.
Battery Back-up Systems
This model has two separate battery back up systems. There is a built in 3-Volt
CR2430 long life lithium battery that will maintain the clock settings, the alarm
settings and the tuner preset memory settings. The lithium battery may last for up
to five years or even longer, depending on the frequency and length of the power
interruptions that you experience in your home. If AC power is interrupted the
display will go off but the lithium battery will continue to power the clock. When AC
power is restored the display comes on again and all your settings are correct.
We have also provided a separate Sure-Alarm battery back up circuit that requires
a 9-Volt battery, not included.
If you install a 9-Volt battery, the buzzer alarm will operate in BUZZER or RADIO
mode, even if the power is off at the selected wake-up time.
CKD5811_080306.p65

PREPARATION FOR USE

5
5 11/8/2006, 11:57