Listening To The Radio - Emerson Research SmartSet CKD5811 Owner's Manual

Listening To The Radio

1.) Press the POWER ON/OFF button on the top panel. The display will change
from time to radio frequency. The first time you turn your unit on the display will
show FM 87.5 MHz.
2.) To switch between the FM and AM bands press the AM/FM button. The first
time you select the AM band the display will show AM 520 KHz.
3.) Tune to the desired station with the
follows:
Manual Tuning
•
Repeatedly press either the
frequency of the desired station.
Automatic Tuning
•
Depress and hold either the
then release the button. The tuner searches down or up the band until it finds
a strong signal and then stops on that station. Repeat this process until the
tuner stops on the desired station.
4.) If you tuned to an FM Stereo station the
FM ST indicator appears in the display.
5.) Five seconds after you release the
changes from radio frequency back to the correct time.
To see the station frequency again, press the TIME button. The display will
change from time to radio frequency for 5 seconds and then return to the
correct time
6.) Adjust the VOLUME control on the right side of the cabinet to the desired level.
7.) When you are finished listening press the POWER ON/OFF button to shut the
power ' Off' .
Note: The Tuner remembers the last station that was tuned before the power
is switched off and automatically returns to that station when the power is
switched on again.
CKD5811_080306.p65
or
or
button until the display shows the
or
button until the display begins to move,
or
16
16
buttons on the top panel as
button the display automatically
3/8/2006, 11:01