Table of Contents
Advertisement
Removing an I/O-module interposer
To remove an I/O-module interposer or tray, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the I/O module or filler from the I/O-module bay (see "Removing an I/O
3. Pull the interposer release handle to the open position. The interposer moves
4. Slide the interposer out of the bay.
34
BladeCenter HT Type 8740 and 8750: Installation and User's Guide
I/O filler tray
I/O bay filler
Handle
(open)
on page 26.
module" on page 33).
out of the bay approximately 0.6 cm (0.25 inch).
I/O module interposer
Advertisement
Table of Contents
