Hitachi CPS210W User Manual page 64

WARNING The projector uses a high-pressure mercury glass lamp made of
glass. The lamp can break with a loud bang, or burn out, if jolted or scratched,
handled while hot, or worn over time. Note that each lamp has a different lifetime, and
some may burst or burn out soon after you start using them. In addition, when the bulb
bursts, it is possible for shards of glass to fly into the lamp housing, and for gas
containing mercury to escape from the projector's vent holes.
• Please carefully read the section "Lamp" of "User's Manual – Safety Guide".
• Do not open the lamp cover, if the projector is mounted on the ceiling, or if the lamp
has broken. Ask your dealer to replace the lamp.
• Before replacing the lamp, make sure the power switch is off and the power cable is
not plugged in, then wait at least 45 minutes for the lamp to cool sufficiently.
• Use the lamp of the specified type only. Type number: DT00581 (sold separately)
Do not use old (used) lamps; this is a cause of breakage.
CAUTION • Do not reset the lamp timer without replacing the lamp.
If the indicators or a message prompts you to replace the lamp, replace the lamp
as soon as possible.
Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at
1
least 45 minutes.
Contact your local dealer to prepare a new lamp. Tell the dealer your lamp type number.
2
If the projector is mounted on the ceiling, or if the lamp has broken, also ask the dealer
to replace the lamp.
In the case of replacement by yourself,
After making sure that the projector has cooled adequately,
3
slowly flip over the projector, so that the bottom is facing up.
Hold the release button while sliding and taking the lamp
4
cover up.
Unscrew the 2 screws, and slowly pick up the lamp by the
5
handles.
Insert the new lamp, and tighten the 2 screws firmly to lock
6
it in place.
Slide the lamp cover into place until it locks into position.
7
Slowly turn the projector so that the top is facing up.
8
Turn on the projector, and reset the lamp timer. When the lamp has been replaced after
9
the message of "THE POWER WILL TURN OFF AFTER 0hr." is display, complete the
following operation within 10 minutes of switching power on.
(1) While the projector running, press the MENU button to open the menu.
(2) Choose the "OPTION" on the menu using the
(3) Choose the "LAMP TIME" using the
projector or the RESET button of remote control for 3 seconds.
(4) Choose the "RESET" using the
button, then press the
/
button, then press and hold the
/
button.
Lamp cover
Release
button
Handles
Screws
button or ENTER button.
button of
7