Download
Share
Print this page
Hitachi SJ300 Setup Instructions
  1. Manuals
  2. Brands
  3. Hitachi Manuals
  4. Power Tool
  5. SJ300 Series
  6. Setup instructions
Hitachi SJ300 Setup Instructions

Hitachi SJ300 Setup Instructions

Closed loop vector control electronic gearing (master/slave)
Hide thumbs Also See for SJ300:
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual See also: Service Manual, Instruction Manual
Application Note: SJ300
Closed Loop Vector
Control - Electronic
Gearing (Master/Slave)
Please refer also to the
Inverter Instruction Manual
AN110602-1
Hitachi America, Ltd.
© 2002 Hitachi America, Ltd.

Advertisement

loading

Related Manuals for Hitachi SJ300

Summary of Contents for Hitachi SJ300

  • Page 1 Application Note: SJ300 Closed Loop Vector Control - Electronic Gearing (Master/Slave) Please refer also to the Inverter Instruction Manual AN110602-1 Hitachi America, Ltd. © 2002 Hitachi America, Ltd.
  • Page 2 SJ300 Closed Loop Vector Control Electronic Gearing (Master/Slave)
  • Page 3 3.1. Flat blade screwdriver 3.2. Philips screwdriver 3.3. Diagonal cutters 3.4. Wire strippers 4. Reference material 4.1. NB613X Hitachi SJ300 manual 4.2. NB616X Hitachi SJ-FB manual 4.3. NEC article 430 4.4. Nation Electrical Installation Standards (NEIS) 4.5. NEMA ICS 2.3 4.6.
  • Page 4 7. Drive parameter set-up (performed on both master and slave drives) 7.1. Preliminary test. 7.1.1. The goal is to set-up both master and slave drive as a standard closed loop vector drives first before making the minor changes for electronic gearing. 7.1.2.
  • Page 5 8.3. Slave set-up. 8.3.1. Parameter changes. P012 01 – APR mode (position) C001-C008 (any single address) 48 – STAT pulse train input valid C001-C008 (any single address) 47 – PCLR position deviation clear C001-C008 (any single address) 46 – LAC LAD cancel A001 04 –...
  • Page 6 TM2 – second 4 terminals are pulse output to slave devices TM1 – encoder wire TM2 – first 4 terminals connections for closed are pulse in control loop vector control 48, 47, and 46 must be addressed to 3 intelligent input terminals on the slave drive.
  • Page 7 A081 – set to 00 A082 – set to value to motor nameplate voltage A001 and A002 set to local control for initial testing purposes Note: A001 of slave must be set to 04 after initial testing is performed (refer to part 8.3 of this document).
  • Page 8 A044 – set to 05 for closed loop vector control Note: It is suggested to go through the local auto- tune procedure versus using the software wizard. After auto-tune is complete (symbol ___0) Ensure that H002 is set to 01 or 02...
  • Page 9 P010 – set to 01 for both velocity and electronic gearing. P012 – set to 01 on slave ONLY! (refer to 8.3 of this document). After initial electronic gearing tests are performed, the gearing ratio can be changed by these parameters (P20 &...