Table of Contents
Advertisement
• Keep the cover pressed down on the
points marked by the arrows and close
the engine compartment lid.
Two people are required to carry out
the operation, in order to avoid that
the cover touches the lid due to uneven
pressure.
• Working in pair, stand on the two sides
of the vehicle and, using both hands, first
lift the rear end of the cover (1ª) then
push it (2ª) and lift it towards the rear
(3ª), until it has reached the maximum
opening position. The toolkit box,
adequately protected, may be used to
support the cover in this position if you
do not have a suitable support.
68
2a
3a
• Working in the central area behind the
roll bar, underneath the covering D,
follow the cable
with your fingers,
until you reach the motor
that controls
the side flaps.
• When you reach the end section of
the retaining clip , push it upwards
to release it from the motor. Perform
the same operation on both sides of
the motor, remembering to keep the
retaining springs.
1a
D
5
3
• Detach the two cables from the motor
and strongly pull them outwards.
After closing, the cables will remain detached
from the control motor, and the vehicle must
be taken to a Ferrari Service Network
centre to have the controls checked and
synchronised.
5
3
4
Advertisement
Chapters
Table of Contents
