Function Menu - Hitachi CMP4202E User Manual

OPERATING INSTRUCTIONS (continued)
DISPLAY MENU (continued)
TIPS
Using a wide-screen monitor
• This monitor has a screen mode selection feature. If an incompatible screen mode is selected to play certain software, such as a TV
program, the image would appear different from the original. Take this into consideration when making screen mode choices.
• Use of this monitor in its enlarged display mode with the wide feature enabled in coffee shops, hotels and other establishments for
commercial or pubic viewing purposes could infringe on the copyright holder's right protected by Copyright Law.
• When a normal 4:3 image is displayed over the entire screen in the PANORAMA mode, not the Wide mode, parts of the periphery of the
image may disappear and/or appear distorted in some cases. Use the 4:3 mode to view images, which were created in 4:3 mode.
This mode allows 4:3 content to be viewed without picture distortion.

FUNCTION MENU

MAIN MENU
PICTURE
SOUND
MENU
DISPLAY
FUNCTION
OTHER
Selected characters
RGB1 SIGNAL
RGB
(RGB2 SIGNAL
COMPONENT
(COMPONENT1, 2)
COLOR SYSTEM
RGB VIDEO
OFF
This function can only be used when the optional video unit has been inserted.
SEL. ENT ENT. RTN END
COMPONENT
AUTO YC C YP
B R
AUTO1 NTSC PAL
N-PAL M-PAL
ON
RGB
FUNCTION MENU
ENTER RGB1 SIGNAL : RGB
RGB2 SIGNAL : RGB
SEL. ADJ. RTN BACK
FUNCTION MENU
RGB1 SIGNAL : COMPONENT
COMPONENT1 : AUTO
RGB2 SIGNAL : RGB
COMPONENT2 : AUTO
SEL. ADJ. RTN BACK
Sets to the signal output of the device to be connected to RGB I and
RGB 2 jacks.
P MUSE
B R
Setup matching the color matrix format of the signal to be input.
Switch the color system to suit the input system in video input mode
VIDEO1.
SECAM
• Normally, set to AUTO1. The input signal system will be
4-NTSC
automatically recognized to display input images on the screen
(NTSC, PAL, NTSC4.43).
• If the input signal contains much noise or has a low level at AUTO1
and the operation is found erratic, set to match the input system.
Compatible with European standard SCART signals. Inputs
composite signals of video equipment to composite terminal and
RGB signals of video equipment to connect R output to P
terminal, G output to Y terminal and B output to P
Normally set to OFF.
* Cannot switch to VIDEO2 when ON is selected.
(This function can only be used when
the optional video unit has been
inserted.)
VIDEO 1
FUNCTION MENU
COLOR SYSTEM : AUTO 1
RGB VIDEO : OFF
SEL. ADJ. RTN BACK
VIDEO 2
FUNCTION MENU
COMPONENT : AUTO
SEL. ADJ. RTN BACK
Setup hint
(C
R
(C ) terminal.
B B
)
R