Connecting To A Video Imaging Device - Hitachi CMP4202E User Manual

INSTALLATION INSTRUCTIONS (continued)

Connecting to a Video Imaging Device

(When the optional video unit is installed.)
(1) Make sure that the power switch of the imaging device is turned off.
(2) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
Speaker (R)
VIDEO 1
Power
cable
• If video equipment with an S video output terminal is used, cabling by
the S video cable is recommended to provide finer video quality. (If
an S video input terminal and a video input terminal connect to the
monitor at the same time, S video input would govern.)
• If the VIDEO1 OUT terminal is connected to an external monitor with a
75 Ohm terminal, it is possible to view the same image as on the main
unit. If an external monitor is not being used, the cable must be
removed from the VIDEO OUT terminal. The image will appear white
as saturation level is reached.
With RGB component setup
RGB 2 RGB 1
RS232C
D-SUB IN
D-SUB IN
With SCART terminal connection (refer to
AUDIO IN COMPOSITE S COMPONENT IN
VIDEO 1
R L/MONO R L/MONO
P /C P /C
IN OUT IN R R B B
Monitor rear panel
Power cable
connector
AUDIO IN S
COMPOSITE
L/MONO R L/MONO
R
IN OUT IN
To composite
output terminals
AUDIO IN
To component video
equipment.
Please use the connection cable
suitable for the terminal form of
video equipment.
)
Video equipment
VIDEO 2
Y
a DVD player, and a video camera)
COMPONENT IN
VIDEO 2
P /C P /C Y
R R B B
Use if the
video
equipment
has an
S video
input terminal
Speaker Connection
This device is equipped with speaker output jacks for use in
connecting a speaker system (optional). Refer to the diagram
below to connect.
CAUTIONS
When connecting speakers, connect the plus (+) speaker terminal
and the plus (+) speaker terminal of this device, and connect the
respective minus (-) terminal in the same way. The sound will not
be correct if plus (+) and minus (-) terminal are connected to each
other.
Speaker (L)
Video equipment
(such as a video disc player,
10 Remove the insulation
and twist the bare cable
as shown.
Down the tab and insert
the cable.
Press the tab up to
prevent the cable being
pulled out.
External Monitor
COMPOSITE S
IN OUT IN
To composite
input terminals