Installation; Unpacking - Hotpoint WF760 Installation And Troubleshooting Manual

Installation

! Keep this instruction book on hand in order to refer to it
GB
when necessary. Take it with you when you move, and
should you sell this appliance or pass it on to another
party, make sure that this booklet is supplied along
with the appliance so that the new owner may be
informed about warnings and suggestions on how the
machine works.

Unpacking

4
1. Using scissors, cut
carefully along one corner
post to remove the film.
2. Open the door and
check inside the drum.
Remove the transit tube (if
applicable - not all models).
! Retain all packaging
material until installation
is complete.
3. Lift off the polystyrene
top cap and remove the
four corner posts.
4. Carefully lay the left
side of the machine down
onto the top cap.
! We recommend that a
second person helps to
raise and lower the
machine.
! IMPORTANT check
when unpacking your
machine:
If it has broken off and is still in the machine...
remove it... while the machine is still laying on its
side on the top cap.
! Protect the environment - please dispose of the
packaging material carefully and considerately.
5. Remove the
polystyrene base.
! This is a part of the
polystyrene base and
should have stayed intact
when you removed the
base.
6. Cut out the perforated
shape in the transit tube
you removed from the
drum (if applicable - see
Step 2). Follow instructions
listed on the cut out to fit it
to the base of the machine.
When fitted this panel aids
noise reduction.
7. Stand the machine
upright.
! We recommend that a
second person helps to
raise and lower the
machine.
! Continue to read the
rest of these instructions
carefully; the following
pages contain important
information on installation
and troubleshooting.