M-Audio Delta 66 User Manual page 28

1. Plug the guitar into the channel-1 Line input of the pre-amp.
microphone into the channel-2 Mic input.
2. Plug the outputs 1 & 2 of the pre-amp into the Delta 66's analog inputs 1 & 2.
Both are balanced outputs and inputs (respectively), so use a high quality TRS
cable. Most balanced lines run at +4dB line level, so let's set our
+4/Consumer/-10 switches to +4dB on inputs 1 & 2. Open the Delta Control
Panel by double clicking the icon in your Windows Control Panel, and then
click on the 'Hardware Settings' tab. Locate the 'Variable Signal Levels'
section. The +4 setting requires that the +4 radio button be selected.
3. Plug the hardware outputs 1 & 2 of the Delta 66 to a sound system or power amp
with speakers. If your sound system is a consumer type, set the +4/Consumer/-
10 switch in the Hardware Settings page to the –10 setting. The –10 setting
requires that the -10 radio button be selected, setting all of the outputs to the
–10dBV setting. Now minimize the Delta Control Panel.
4. Turn on your equipment in this suggested order: computer, pre-amp, then sound
system.
We're now physically set up to monitor, record, and play back audio. The next steps
involve further configuring the Delta Control Panel software and also the music
27
Plug the