Cannot Connect In Advanced Connection Mode - Epson PowerLite 1760W Operation Manual

Troubleshooting
Check
Is the firewall turned off, or has the firewall been
registered as an exception?
Is Wireless LAN Power set to Off in the Wireless LAN menu
from the projector's Configuration menu?
Is the AirMac setting for Mac OS correct?

Cannot connect in Advanced Connection Mode.

Check
Is the SSID setting different?
Is the same WEP key set?
Are the connection denial functions, such as MAC
g
Address restrictions and port restrictions, set correctly at
the access point?
Are the IP address, the subnet mask, and the gateway
address for the access point and the projector set
correctly?
Are the access point and the projector's subnet different? Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
Have you enabled DHCP?
When you do not wish to turn off the firewall or register the firewall as an exception, make the
necessary settings to open the ports.
The ports used by EasyMP Network Projection are "3620", "3621", and "3629".
Set Wireless LAN Power to On in the Wireless LAN menu from the Configuration menu.
See your projector User's Guide for details on the projector's wireless LAN settings.
Check that AirMac is set to on. Or, check whether an appropriate access point has been selected.
Set the computer, the access point, and the projector to the same SSID.
You can make the SSID setting from the projector's Network menu.
See your projector User's Guide for details.
When selecting WEP from Security, set the access point, the computer, and the projector to the same
WEP key.
See your projector User's Guide for details on the WEP key.
Set connection permission at the access point to allow projectors to connect.
When not using a DHCP, adjust each setting.
You can make the DHCP setting from the projector's Network menu.
See your projector User's Guide for details.
s "Specifying Either an IP Address or Projector Name and Performing a Search (Advanced
Connection Mode Only)" p.17
When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby
status if an available DHCP server is not found.
Remedy
Remedy
41