Solutions When You Cannot Connect Using Advanced Connection Mode (Wireless) - Epson EasyMP Network Projection Operation Manual

Solving Network Connection Problems
Related Links
• "Solving Network Connection Problems"
• "Set options - General settings"
• "Changing the Computer Projection Source"
Solutions When You Cannot Connect Using
Advanced Connection Mode (Wireless)
When you cannot connect the computer and the projector using Advanced
Connection Mode over a wireless network, try the following solutions.
• Check the status of the external devices used for the network
connection or the projector's setting environment.
• Connect the specified wireless LAN unit to the projector securely.
• Check for any obstacles between the access point and the
computer or projector, and change their position to improve
communication. Sometimes, indoor environments prevent the
projector from being found in a search.
• Set the radio strength for the network devices to the maximum.
• Set the IP address, the subnet mask, and the gateway address for
the access point correctly.
p.51
p.68
p.35
• Check the projector's network settings.
• Set the Connection Mode setting to Advanced.
Go to Network > Network Configuration > Wireless LAN > Con-
nection Mode.
• Set the computer, the access point, and the projector to the same
SSID.
Go to Network > Network Configuration > Wireless LAN >
SSID.
• Set DHCP to Off. When DHCP is set to On, it may take some
time to enter LAN standby status if an available DHCP server is
not found.
Go to Network > Network Configuration > Wireless LAN >
DHCP or Network > Network Configuration > Wireless LAN >
IP Settings > DHCP.
• Set the IP address, the subnet mask, and the gateway address for
the projector correctly.
• Set Wireless LAN Power to On.
Go to Network > Network Configuration > Wireless LAN >
Wireless LAN Power.
• Set the wireless LAN system to meet the standards supported by
the access point.
Go to Network > Network Configuration > Wireless LAN >
Wireless LAN system or Wireless LAN Sys.
• When you enable the security setting, set the same passphrase to
the access point, the computer, and the projector.
• Close network settings on the projector, and then return to the
LAN standby screen.
52