Epson Stylus COLOR 1160 Service Manual page 82

EPSON Stylus COLOR 860/1160
C298PSB/PSE
No1. Screws
Board
Shield Plate M/B
Assembly
No5. Screws
Figure 4-4. Removing Each Circuit Board
n
Since the CN10 is a locking connector, be sure to release
the locks before removing the cables.
Also, make sure to lock them when connecting the cable.
Disassembly and Assembly
C298MAIN Board
Earth Plate
No1. Screws
Disassembly Procedures
Be sure to perform the following adjustments after replacing
the Main Board;
1. Head voltage ID Input (Refer to Chapter 5.)
2. Bi-D adjustment, including Head Gap Adjustment (Refer
to Chapter 5.)
3. USB ID data input (Refer to Chapter 5.)
Be sure to exchange the following parts also when replacing
the Main Board;
1. Waste Ink Absorption Pad
2. Ink Cartridge (BK & Color)
This parts exchange is required since the several ink
counters stored in the EEPROM are lost when the Main Board
is replaced.
Make sure each cable is set in the correct cable holder (A or
B) on the M/B Shield Plate. Refer to Figure 4-5.
Cable Holder A
PE Detector
Cable
Panel FFC
ASF HP Sensor Cable
Figure 4-5. Setting the Cables to Holders A and B
Revision C
Cable Holder B
Head FFC
CR, PF Motors
CR Encoder Sensor FFC
82